molding pressure

But fiber volume fraction are raised via elevating molding pressure, when the molding pressure are too high the fibers will be damaged seriously, the composites will become brittler and show poor mechanical properties as a result.

但是纤维体积分数的增加要通过提高模压压力来实现，当模压压力过大时，纤维出现机械损伤，复合材料变脆、力学性能降低。

互联网摘选

Different body molding pressure, optimal value ceramic binder content is different.

不同的坯体成型压力下，陶瓷粘结剂含量最优值是不同。

互联网摘选

Influence of molding pressure and dunking time on the sulfate attack resistant nature of concrete

成型压力和浸泡时间对混凝土抗硫酸盐侵蚀性能的影响

互联网摘选

The results show that the tensile strength of the UHMWPE fiber strands is greatly decreased when the temperature is higher than 123 ℃, and the ballistic absorption energy is up to the highest value when the molding pressure is about 12.5 MPa.

结果表明，温度超过123℃后拉伸强度有大幅的下降，而成型压力为12.5MPa时达到最大值。

互联网摘选

The percentage reduction in molding pressure is higher if part becomes thinner when using ICM.

使用射出压缩成型时成品较薄的部分成品压力变化的百分之将提高.

互联网摘选